SP2SD, SPIISD, SP][SD v2 Case

This is a case designed for either the 0.96" or 1.54" OLED display versions of the SP][SD v2, created by Kero's Mac Mods:
https://en.infinityproducts.co.jp/product-page/spiisd-v2-diy-kit

The top case and display support are specific to the display size, but all other parts are universal.

To install the display support, pull the OLED display off the header, slide the support over the header and then put the display back (as pictured).

There is a small tube or "light tunnel" for carrying the light up from the PCB to the front of the case. If you want to make the light even brighter, you can put a 100mm length of clear filament into the tube to carry the light through to the top of the case.

NOTE: I have recently made an update to this design and the new files are prefixed as "SP][SD v2". There were some areas where the plastic was too thin and I have added a "light tunnel" for the LED to shine more clearly through the front of the case. Files that don't have the "SP][SD v2" prefix a