Thingiverse
Space Wall - Wall Decoration
von jhaamdath
179
Downloads
159
Likes
0
Makes
roject inspired by great Saturn V model by dougfieg https://www.thingiverse.com/thing:3669291
Saturn V looked quite lonely after printing it. So I've decided to fill whole wall with space related stuff.
So the idea of "Space Wall" was born. Took some time but the end results looks great.
All models are in same scale, with exception of sputnik since it would be very small.
Printing tips:
0.3mm layer height, 100% infill. Black PLA. I recommend turning off fan, had some problems with adhesion with fan on.
Let it cool off on bed, since right after printing it will be still bit bendy.
If you are printing on glass flip 180 deg so exposed side will be smooth.
Attach to wall with 2 sided tape.
Models sliced to fit on most printers.
You can bump height to have more rigid frame, but 2.4mm works fine.
Extras - logos for printing in different color. Flip 180 deg, use two sided tape and then remove from bed. This way you keep spacing in logos when attaching to wall.
Bottom
Saturn V looked quite lonely after printing it. So I've decided to fill whole wall with space related stuff.
So the idea of "Space Wall" was born. Took some time but the end results looks great.
All models are in same scale, with exception of sputnik since it would be very small.
Printing tips:
0.3mm layer height, 100% infill. Black PLA. I recommend turning off fan, had some problems with adhesion with fan on.
Let it cool off on bed, since right after printing it will be still bit bendy.
If you are printing on glass flip 180 deg so exposed side will be smooth.
Attach to wall with 2 sided tape.
Models sliced to fit on most printers.
You can bump height to have more rigid frame, but 2.4mm works fine.
Extras - logos for printing in different color. Flip 180 deg, use two sided tape and then remove from bed. This way you keep spacing in logos when attaching to wall.
Bottom
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
