Space X coaster 90mm

Here's a nice looking Space X style coaster based on the landing site graphics. This prints as 10 parts that assemble together to make the logo with the inner ring slightly recessed.

Printing:
The outside ring and X are printed in white.
The inner circle can be printed in yellow or orange, or in white and painted.
The base is printed in black.

Assembly:
Stretch the outside ring around the base. It will fit and won't require glue. If it's too tight, flip it over so the base printed side goes up. If it's still a problem, it might require a little sanding on the inside of the ring.

Next, slide the pointy bit of the streak on the X along the path. May require a little force to get it in. It's supposed to be a tight fit. Add a little superglue to the base and glue it into place.

The diagonals of the X may be attached to the swoop depending on your printer calibration. If not, glue them into place.

The inner circle - start with the 2 pieces on either side of the swoop