Thingiverse
SpaceMouse 3dPrinted case
von Davideza
5
Downloads
2
Likes
0
Makes
A simple 3d printed case for the 3Dconnexion SpaceMouse Wireless and its USB dongle.
Both parts can be printed flat surfaces down without supports.
Warning: This mouse is very heavy, and the friction between the top and bottom is not enought to keep it closed in some situations, for example, holding it only from the top is very risky. Another lock design will be needed for that. For my use, wich is protecting the mouse in a backpack, is more than enought. I printed it at a 0.1mm layer height with PLA. Keep in mind this because tolerances between top and bottom while vary with different parameters, materials or machines.
Both parts can be printed flat surfaces down without supports.
Warning: This mouse is very heavy, and the friction between the top and bottom is not enought to keep it closed in some situations, for example, holding it only from the top is very risky. Another lock design will be needed for that. For my use, wich is protecting the mouse in a backpack, is more than enought. I printed it at a 0.1mm layer height with PLA. Keep in mind this because tolerances between top and bottom while vary with different parameters, materials or machines.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!