MakerWorld
Electronics
Go to Model
SpaceNavigator Knob
65
Downloads
14
Likes
28
Makes
The knob for my 3DConnexion SpaceNavigator mouse became sticky, because of the rubber deteriorating. So I designed a new knob. To replace the knob follow the following steps:remove the top cap of the original knob by prying it of with a small screwdriverremove the three screws holding the knobplace the new knob and turn it until you feel it snap into placeinstall your new knob with the three screwspress in the top 3D printed plateEnjoy your new knob :-)Boost MeA boost would be appreciated if you like my design.
Sander also publishes on
53 additional models across 5 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
