Thingiverse
SpaceX Helmet Replica
door macktruck
450
Downloads
364
Likes
1
Makes
Warning:
This is an early version of the SpaceX certification helmet replica that I designed. (the replica, not the actual helmet) Version 1 has been successfully printed although the small inserts may be to thin to print. A possible replacement is card stock. At this point, I make no grantee that version 2 pieces will fit.
Current scale is meant for a 6.5 inch wide head with the helmet's wide at approximately 8.5 inches. Check pieces for sufficient width when scaling down for children.
History:
This is my attempt at replicating the SpaceX helmet that was used for certification for astronauts on the Dragon V2 as part of NASA's Commercial Crew incentive to launch astronauts from America soil. The first certification flight of Dragon V2 (DM-1) will hopefully occur in January of 2019 from the historic launch complex 39a in Cape Canaveral Florida.
My Media:
https://www.youtube.com/watch?v=Q_RGK8KKz8Y
Revision History:
V1 - Between 12/26 and 12/31 - Original version
V2 -
This is an early version of the SpaceX certification helmet replica that I designed. (the replica, not the actual helmet) Version 1 has been successfully printed although the small inserts may be to thin to print. A possible replacement is card stock. At this point, I make no grantee that version 2 pieces will fit.
Current scale is meant for a 6.5 inch wide head with the helmet's wide at approximately 8.5 inches. Check pieces for sufficient width when scaling down for children.
History:
This is my attempt at replicating the SpaceX helmet that was used for certification for astronauts on the Dragon V2 as part of NASA's Commercial Crew incentive to launch astronauts from America soil. The first certification flight of Dragon V2 (DM-1) will hopefully occur in January of 2019 from the historic launch complex 39a in Cape Canaveral Florida.
My Media:
https://www.youtube.com/watch?v=Q_RGK8KKz8Y
Revision History:
V1 - Between 12/26 and 12/31 - Original version
V2 -
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!