Spare Hotend holder

Better than V.1 - This new version gives more support to the bottom of the heatsink for hotends without a fan attached.Added 6x 6mm holes for keeping your spare nozzles.Tighter spacing across the board. These printable theater seats for your hotends hold the assembly in place without putting any stress on your heatsink, fans, or nozzles.Put your hotends on display with this tidy 6 section theater seat array. The tray is designed to hold 6 Hotends when they are not in use. Holds Hotends with wide boot, like Mako Hotend as well as array of assembly levels from complete hot ends (+Fan) to bare hot ends w/o ceramic heater.Printed without supports, 2 walls is fine. I had new flashforge abs pro burnt titanium, this was my first print with, I think that I over heated the filament - went to 3 walls + reduced temp and the walls look much better.Nothing too intricate about this design, should be fine with almost any layer height.This is not going to grab your hotend and hold it. Hotends sit in a