Spark GO tripod mount

The Spark Go is a mini guitar practice amp that sounds great but sounds even better elevated to ear level. This mount allows you to attach the Spark Go to a tripod. It uses a hex nut that's compatible with standard tripod screw. With a layer height of 0.2mm you will want to pause the print at layer 40 to insert the nut and then resume print.

Instructions: unscrew the strap screw, insert amp in mount, screw in strap screw. Screw mount to tripod.

Tip: It sits better in the mount if you don't over tighten the strap screw.

A whole lot of screwing going on :)

Here's the nut details:

(face palm)

https://www.grainger.com/product/5YE51?gucid=N:N:PS:Paid:MS:CSM-2295:YF1CA5:20501201:APZ_1&gclid=3e98ebe8745814afbd6d83c754c2e951&gclsrc=3p.ds&msclkid=3e98ebe8745814afbd6d83c754c2e951

Hex Nut: 1/4"-20 Thread Size UNC

It measures about 11mm across (flat end to flat end) and 5.6mm thick.