Sparkfun Photon Weather Shield Case

A simple case for the [Sparkfun Photon Weather Shield](https://www.sparkfun.com/products/13674). Has cutouts for the onboard Rj plugs, USB for power, external antennae wire, and pinholes for the status light and to hit the reset and setup buttons on the photon. The pinhole for the light is 1.75mm so you can use a piece of clear filament to act as a lightguide, but I haven't found it necessary.

Large cutout for the onboard sensors has baffles to limit the error introduced by ambient heat created by the electronics, however, I have found that the board reads a couple degrees warmer in the case than it does bare.

Holds together with two 6mm M3 screws and nuts. The nuts could be secures with a CA glue, but I found that they friction fit well enough that I could assemble the case upside-down without trouble.

4mm holes on the mounting ears should accept up to #8 screws for wall mounting.