Sparkmaker Resin Tower test v4

NOTE: THE CODE ONLY WORK WITH SPARKMAKER!!!

This tower test are just a guage on how your resin will print with sparkmaker's printer.

The pole on the model are to guage how well your sparkmaker and the resin will print on diff cure time.

If you notice that the 1mm pole don't print well on one of the pre set cure section, it not recommend to use that cure time on that affected section.

This is a resin cure time test tower for SParkmaker DLP Printer.

It will print the tower with a decrements of 2sec per 10mm height.

to print just place the print.wow file to the root of your sdcard and print

How to select your cure time base on the test tower.
- visual inspection on the print, check with which section of cure time give you the best clean print result.
-Once you found the section that give you the best clean print result, use the time lable on that section for your "layer expouser" print setting..

Slice info:
Uv light strength: 255
Layer height: 0.1
z motion