SPDH #2

Use DADH2-008.stl for the latest retrofit and make sure is a new Kit that has the lip around the edge of the assembly

all Below is superceeded by DADH2-008
will make available only by request to prevent confusions.

Retard Roller Support Bracket
uses SFR106ZZ bearing (NOTE 02/18 BEARING MODEL CAN BE USED IF THE TOP COVER TABS ARE REMOVED)
no.5 is no bearing model
Edit: adds clearance to the bottom
Edit: support takes place of E-clip for mounting and clearance from top cover.

Version 6 has a cutout to allow the lip on the base to slip through. I don't have a new assembly so please tr it out and provide feedback thank you
Version 6 Thin has a .8mm width for the e clip, it can be removed if necessary the outer diameter matches the shaft so it can still support it. the piece will be held in place by the new edge groove.
Use shaft from old assembly to make it fit better
Version 6b has the e-clip tab removed and a wider area to support the shaft.

Version 8 prints upside