Speaker Wall Mount - Edifier XM6

ATTENTION : the item's print height is 265mm. make sure your printer can do at least that tall

1) print 2 of them with 1 mirrored

2) supports optional. (touching buildplate)
it only affects the end of the stand where the edges slips between the speaker and the filter.

with supports : lots of extra material needed for a minimal effect, but looks tidy
without supports : is what i did, makes the end part untidy and will leave strings hanging. but i personally felt like it doesn't matter because that part is covered by the spearker itself

3) known issues :
i forgot to think about the space needed for the screwdriver when putting it up. so you would need an extra long screwdrivers to do the top screws