Spectrobes - Spikanor

Another separated model from Spectrobes: Origins, this one being Spikanor.
I think it turned out quite well, especially because I had the motivation to model some custom parts. You may need to drill out the holes on them after printing.
Also be warned that the little kneecaps might be an issue printing. It may take you a couple tries. I highly recommend you print the normal custom part in halves. Similarly, move everything else a bit into the build platform without rotation until you get a flat surface to print on.

Note: This is not my model! It is directly taken from the Wii game, and can be found on https://www.models-resource.com/wii/spectrobesorigins/. I only modified it to allow printing in different colours. However, I did model the two extra tail ends by myself using sprite references from the previous game, Beyond the Portals.