Thingiverse
speedometer magnet holder
door robertl49
6
Downloads
10
Likes
0
Makes
I have got an old BSA motorbike and the speedometer is a bit dodgy.
so I purchased a wifi one as used on pushbikes. the spokes on the motorbike are 1/8th inch (3.2 mm) diameter so the original magnetic holder would not fit. so designed a holder so i could fit 4 small magnets in and would fit the spokes.
magnet are 5mm dia x 2mm thick, glued in
so I purchased a wifi one as used on pushbikes. the spokes on the motorbike are 1/8th inch (3.2 mm) diameter so the original magnetic holder would not fit. so designed a holder so i could fit 4 small magnets in and would fit the spokes.
magnet are 5mm dia x 2mm thick, glued in
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
