Thingiverse
Speeduino Case - MX5
door n00bz0rz
6
Downloads
0
Likes
0
Makes
Case for 0.4.3c speeduino board, with space for alternator controller from Westfield MX-5.
This is designed to be a drop in replacement for the factory ECU on a MK2.5 Mazda MX-5, this may work for NB variants but this has not been tested as I don't have access to one.
Factory brackets are retained, holes must be tapped M5 to use the factory screws.
The Arduino Mega first screws to the base into the standoffs, the holes are sized to be threaded M3, the ECU plug is designed to have its leads clipped off and screwed directly to the available holes on the front of the case. This will stick out compared to the original, this is by design to provide clearance for cables to be ran.
Source files available here: https://a360.co/3hjHmib
This is designed to be a drop in replacement for the factory ECU on a MK2.5 Mazda MX-5, this may work for NB variants but this has not been tested as I don't have access to one.
Factory brackets are retained, holes must be tapped M5 to use the factory screws.
The Arduino Mega first screws to the base into the standoffs, the holes are sized to be threaded M3, the ECU plug is designed to have its leads clipped off and screwed directly to the available holes on the front of the case. This will stick out compared to the original, this is by design to provide clearance for cables to be ran.
Source files available here: https://a360.co/3hjHmib
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!