Spell Effect Chill Shield or Flame Shield

This is a Spell Effect Fire or Chill Shield

Remixed from:

The ring of fire
by SebTheis
https://www.thingiverse.com/thing:3662905

...Which was a remix of:

Wall of Fire 28mm RPG
by Talismancer
https://www.thingiverse.com/thing:2050261

I removed the small portion of the the ring of fire, duplicated what was left, rotated the second 180 degrees, aligned and joined them within Meshmixer. I did a quick removal of the seams, touched up a few of the flatter portions of the exterior flames, sized, hollowed the center to fit a standard figure base at 25mm, and printed to create the chill version.

My printer is an Ender 3 with a 0.4 nozzle diameter. I started with the LH profile (Luke Hatfield). I then set infill to 0%, initial layer to 106%, print speed to 40mm/s, temperatures to 225C for all nozzle temps and 55C for all bed temps. I put blue tape as well on the heated glass just to be sure I didn’t lose adhesion.

I had some stringing which I heated with a shrink tube h