Thingiverse
Spherical Lithophane Stand
by littleSilvr
44
Downloads
56
Likes
0
Makes
Posted this on Reddit, got a lot of requests to post the stand - here it is.
Used https://www.thingiverse.com/thing:3242080 for the moon itself, fantastic print.
The large hole is to put a 20mm switch in to turn the lamp on while the small hole on the other side is to allow a USB cable to feed power into the system. The stand cap is used to feed the wiring through to your lights and allow you to attach your lights to the stand.
Used this for the moon print but you can use it for any spherical lithophane of 4" in diameter, just sink the sphere into the print surface by 15mm and it should snap-in.
If you need a different design for a different switch or something like that just let me know and we can work something out :)
Used https://www.thingiverse.com/thing:3242080 for the moon itself, fantastic print.
The large hole is to put a 20mm switch in to turn the lamp on while the small hole on the other side is to allow a USB cable to feed power into the system. The stand cap is used to feed the wiring through to your lights and allow you to attach your lights to the stand.
Used this for the moon print but you can use it for any spherical lithophane of 4" in diameter, just sink the sphere into the print surface by 15mm and it should snap-in.
If you need a different design for a different switch or something like that just let me know and we can work something out :)
littleSilvr also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
