Thingiverse
SPICE HOLDER
von Spettro88
0
Downloads
1
Likes
0
Makes
Design Concept
This spice rack was designed mainly for my boat, the spice racks fit together and remain immobile, but they can also be applied with small screws behind wooden kitchen doors.
Print Setting
K1 Printer, 30m print time, 0.16 layer height, 30% infill, PLA material, no support.
This spice rack was designed mainly for my boat, the spice racks fit together and remain immobile, but they can also be applied with small screws behind wooden kitchen doors.
Print Setting
K1 Printer, 30m print time, 0.16 layer height, 30% infill, PLA material, no support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
