Slicer Discord
Spice rack for 120ml jars – 3D-printbaar model van Thingiverse Thingiverse

Spice rack for 120ml jars

39 Downloads
83 Likes
0 Makes
Model downloaden
This spice rack was designed to hold 120ml jars that are roughly 4.7cm square. The jars are readily available on Amazon, such as these:

https://www.amazon.co.uk/dp/B0CNQ24G9V?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

This rack keeps the jars out in the open and usable but elevated so they don't take up a lot of the workspace. It is divided into 9 pieces, and I just used a silicone adhesive to bond them together and then a bead of silicone (and a couple of dabs on the wall) to hold it in place.

The jars sit at 45 degrees so they are easy to pull out and easy to read the labeling on the lids.

I made mine to hold 32 jars, but you could make it as long as you like by adding more of the middle sections. Each additional middle section would add 8 jars.

There is a cutout to account for an upstand approximately 100mmx20mm
Bron
Thingiverse
Wat je nodig hebt om te printen: Gevorderd Lage betrouwbaarheid
Waarom?
9-delige montage
9 delen te monteren
Supports 1/3
Montage 2/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, ABS
Nabewerking
Lijmen
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie