Spices holder / stand

#Spices holder

##Description
This is a spice holder designed for small spices tubes (~45mm diam, ~10cm height).

##Parts to print
* plate.stl (x1) : ~7,5 hours at 50mm/sec print speed
* holder.stl (x6) : ~1,5 hours at 50mm/sec for each holder, less if multiple prints at once
Total print time : ~15 hours

##Assembly
The holders fits right into the plate, there is no need to glue them but I did it anyway just to be sure they won't pop out.

##Notes
On the pictures there is no reinforcement on the bottom plate, I added it after printing to make it a bit stronger but I didn't printed the piece again as it was strong enough as it.




#Print settings

##Quality
* 0.2mm resolution
* 20% infill

##Supports
* No supports
* No raft