MakerWorld
Decor
Go to Model
Spider Web Coaster set
2
Downloads
3
Likes
0
Makes
2-in-1 design lets you use the coasters separately or snap them together. The top coaster (orange in pictures) slots easily into the base. Make sure the x-y contour compensation is set to -0.1mm and the x-y hole compensation is set to 0.2mm for the top coaster. The bottom coaster is fine as is. The fit could be a little tight at first but once it has been in and out 3-5 times the fit is quite satisfying. The top coaster can be flipped and will fit both ways, so you can choose to display your bottom or top surface layer pattern.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
