MakerWorld
3D Printer Accessories
Go to Model
Spidey Controller Basket
107
Downloads
110
Likes
56
Makes
The bottom plate is the correct spelling … Just add glue to the holes on the base :) Prints in 2 partssupports take some time to remove on the top model , but i find it better than using trees. to save time you can change the base to 8% grid infill :) I appreciate any boosts :) the bottom left in the printed model only turned out like that bc of me not realizing my 1st layer wasnt fully adhered until it was too late.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
