Slicer Discord
Spike Knuckles (Spike Knuckles) – 3D printable model from MakerWorld MakerWorld
Cosplay Weapons

Spike Knuckles (Spike Knuckles)

24 Downloads
28 Likes
9 Makes
Go to Model
Knuckles with spikes attachedIt can be dangerous, so please don't use it on people.The largest size is 25mm in diameter of the hole where the finger enters and about 117mm in length in the long direction.The rest are 95% and 90% sizes of the largest size, respectively.After using it myself, I felt that the spike was very sturdy and sharp, and the biggest size was a bit big for me. 스파이크가 부착된 너클위험할 수 있으니 사람들에게 사용하지 말아 주세요.가장 큰 크기는 손가락이 들어가는 구멍의 지름이 25mm이고, 긴 방향의 길이가 약 117mm입니다.나머지는 각각 가장 큰 사이즈의 95%와 90% 크기입니다.직접 사용해보고 나서 스파이크가 매우 튼튼하고 날카롭다고 느꼈고, 가장 큰 사이즈는 저에게 조금 큰 것 같았습니다.
Category
Cosplay Weapons
Source
MakerWorld
Published
Updated
What you need to print this: Intermediate Low confidence
Why?
very large print
Single piece May need scaling or splitting
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 3/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Min. bed size
300 mm (Extra large)
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection