Spiked Rave Bracelet

This is a fun ‘rave’ bracelet but be careful as the spikes are quite sharp. The bracelet is very stretchy and stretches to fit my rather thick wrists; however, if you need to go larger, scaling up both parts by the same value should be fine. I would be careful about scaling the file down, however, as the spikes are already very small. The bracelet need to be printed in TPU or similar flexible filament. The spikes can be printed in PLA. A 0.16mm layer height works well for both parts of the model. The bracelet should be printed at 100% infill.