Thingiverse
Spine bracelet
by Toxn
1
Downloads
3
Likes
0
Makes
A bracelet meant to resemble a spine once assembled.
A large wrist requires about 20 of the individual vertebrae, along with one of each end.
The vertebrae and ends are held together with 0.7mm wire, which is pushed through the holes and pressed flat along the sides of the vertebrae at each end.
Printing for the vertebrae and the male end is best done horizontally, while the female end works best when printed vertically with the opening for the male end facing upwards.
A large wrist requires about 20 of the individual vertebrae, along with one of each end.
The vertebrae and ends are held together with 0.7mm wire, which is pushed through the holes and pressed flat along the sides of the vertebrae at each end.
Printing for the vertebrae and the male end is best done horizontally, while the female end works best when printed vertically with the opening for the male end facing upwards.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
