SpinKnuckle Leverless Controller Enclosure

A newer attempt at my leverless acade stick. Uses actual slim base push buttons 24mm and 30mm (purchased separately; I recommend something like the ST-L2 from Aliexpress). Wiring can be a mess, I recommend NOT using a standard wiring harness and custom wiring your setup and cutting to actual length to make it fit perfectly. Fits most PCBs but I designed it for a Picopi so other things might not fit. I designed it to be screw-less friction fit, so there are notches at the corner for the semi-tool-less access using a coin or a strong finger nail to pop open the enclosure. The entire enclosure is also sloped for comfort. If using on table top, recommended adding anti slip grip tape/mat to bottom. You'll need at least the following: 17x - 24mm (low depth push buttons, 11mm or shallower)01x - 30mm (low depth push button, 11mm or shallower)01x - PicoPi or equivalent fightstick pcb (not tested for larger pcbs could possibly work or modded to fit)optional grommet for cable outlet (will des