Spinner Board

Funny spinner board to hand on a wall. Any kind of drywall screw or standard construction screw should work. The spinner itself attaches with a M3 bolt. It is helpful, although not vital, to put a washer in between the spinner and the board to increase clearance. The letters should come out cleaner than seen in the picture because I used a 0.6mm nozzle. To print it like I did, you will need 5 colors. to do this with one AMS, you can manually switch the color of one of the AMS slots mid print. In the slicer, set the first and fifth color as the same AMS slot. then after the first color is done, switch it to the fifth color to be used later. As is, this will not fit on an A1 Mini, but it can be scaled down.