Spinner - Two Part Assembly

Add support only for the top portion of the spinner, the one with the cross pin outwards, no need to add support for the bottom portion of the spinner. Have fun and let me know if the part is too tight, I left a tolerance of 0.006" for the bottom cross hole.

Read below for printer settings if needed but any should work with normal settings.

Nozzle Temperature: 206C
Bed Temp: 54C

I went with low resolution but there was a layer on the round side that was splitting from the transition (bottom part); stick with standard 0.2mm layer and it will print great. I used 3 walls.