Thingiverse
Spinning Top
by DMUX
1
Downloads
4
Likes
0
Makes
Another spinning top :)
- after print remove triangular supports
- no additional supports is needed
- parts should be fit tightli, otherwise use glue
- 0.12 - 0.28 mm layer / 0.4 mm nozzle / 20 - 100% infill
- after print remove triangular supports
- no additional supports is needed
- parts should be fit tightli, otherwise use glue
- 0.12 - 0.28 mm layer / 0.4 mm nozzle / 20 - 100% infill
DMUX also publishes on
16 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
