Spinning Zoetrope

Update: Added the stand.


This is A Production Stage (aka it works and prints)

Print the handle vertically with prongs on top.With a BRIM. No support
Print the base no supports no brim. this is important.
You slowly fold out each piece after its printed so that it all forms a flat plane. the pieces will tend to lock so go slow and do not over force as you move them outwards.

The handle takes about 30 mins to print and the base a good 6 hours. Phew!

Push prongs of handle into base firmly. It is removable without damage (hopefully) if you need to remove the handle.

Then its best to pick an animation you want to use. And then copy it to one page at several different sizes. This will hopefully give you a match with one of them so that you can cut them out and they will fit the slots. Just remember the % scale and then you can print all the others.

slide the pictures into the spaces and spin to see the animation!

base design coming soon...