SpinRing (spinning fidget ring)

Warning: The Spinner will only print in Simplify3D if you lower the Outline/Perimeter Shells to 1!

Update 21.06.2017:
Updated the whole ring to make it spin faster and added 3 different diameters.
The Spinner itself is the same for all 3 diameters, so print away!

This is the SpinRing, a fidget toy to wear and play around with.

This ring is made of 3 parts. You have to print the base 2 times and the spinner 1 time.

The bases have a groove where you can put superglue in, after that, put the spinner onto the other base and stick the glued one into the other two assembled parts.

It does not spin as fast and as smooth as a fidget spinner, but it is a nice toy to keep your fingers busy.

There are 3 Versions now:
19mm, 17,5mm and 16mm diameter. The Spinner is the same for all three.

Have fun!