Thingiverse
Spiral Bevel Gear
por gearsandmore
244
Descargas
177
Likes
1
Makes
Parts have the following bounding dimensions (X*Y*Z)
BASE.stl: 72mm x 81mm x 63mm
GEAR_Z5.stl: 77mm x 75mm x 24mm
GEAR_Z3.stl: 51mm x 49mm x 32mm
CRANK.stl: 50mm x 20mm x 57mm
KNOB.stl: 20mm x 20mm x 25mm
CAP.stl: 15mm x 15mm x 15mm
Assembly as followed:
1. Put the bigger gear onto the shaft of the base
2. Put the smaller gear in its place by bending the base part a little bit
3. Push the crank through the outer hole of the base body, through the smaller gear until it reaches the hole in the middle shaft of the base
4. Insert the cap to secure the crank from falling out
5. Add the knob to the crank (maybe add some super glue)
BASE.stl: 72mm x 81mm x 63mm
GEAR_Z5.stl: 77mm x 75mm x 24mm
GEAR_Z3.stl: 51mm x 49mm x 32mm
CRANK.stl: 50mm x 20mm x 57mm
KNOB.stl: 20mm x 20mm x 25mm
CAP.stl: 15mm x 15mm x 15mm
Assembly as followed:
1. Put the bigger gear onto the shaft of the base
2. Put the smaller gear in its place by bending the base part a little bit
3. Push the crank through the outer hole of the base body, through the smaller gear until it reaches the hole in the middle shaft of the base
4. Insert the cap to secure the crank from falling out
5. Add the knob to the crank (maybe add some super glue)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
