Spiral Lamp

I am still very new to 3D design and printing. During the design I wasn't sure if the lamp would fit through the gaps of the spirals to allow me to place it at the bottom of the lamp. If the lamp didn't fit, I planned to cut a hole into the bottom of the lamp so I could lay it in place. Because of this, the fllor under the lamp is only 0.2 mm thick. It does still hold the lamp in place nicely. When I am a little more competent in 3D design I may go back and make that base a little thicker. It really does work nice though. I would love to see other colours of this lamp printed. I printed my lamp with “critical supports only” selected and it didn't need any. I was very surprised, pleasantly of course.