Spiral Lamp

My lampshade was way too bright so I decided to make a new one. Along the way, I just decided to make a whole new lamp housing as well. The lampshade is printed in Hatchbox orange PLA and the top thread housing is printed in Tecbears black PETG. The lampshade screws onto the top with a friction fit. I recommend upscaling the top thread part a couple of percent, as my top ended up a slightly loose fit on the shade. Still works fine so I'm not gonna mess with printing another. The thread will need supports only on the side hole if printed upside down. No support needed for the lampshade.