Thingiverse
Spiral Passthrough Cone
por kejgoh
34
Descargas
195
Likes
0
Makes
Designed in Freecad 1.0.
Print settings:
Layer height: 0.08 to 0.2 mm should work fine
Use the relevant settings for your printer and filament.
Two outer cone options provided: One close fit and one loose fit.
Tested to work well on Anycubic PETG and Kobra S1.
Print settings:
Layer height: 0.08 to 0.2 mm should work fine
Use the relevant settings for your printer and filament.
Two outer cone options provided: One close fit and one loose fit.
Tested to work well on Anycubic PETG and Kobra S1.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
