Spiral Vase

Spiral Vase. 200mm high and 90mm wide at widest point. 1mm thick walls printed in vase mode for a smooth finish with no seams, and 8 layer base for a solid foundation.Light weight without using a lot of material, yet very strong and very little flex. Also did a quick test to confirm that it will hold water by filling it to the brim and leaving it on paper towel for an hour - no leaks. Your milage may vary of course. Please note that this has only been tested with PLA (Specifically Bambu Marble PLA in this case). A1 Mini version is scaled down to 89% to fit in the height limit at just below 180mm. My other models:Small Spiral Planter: https://makerworld.com/en/models/620722Spiral Vase - Angular: https://makerworld.com/en/models/632155Spiral Urn Vase: https://makerworld.com/en/models/637190