Spiral Vase

A Spiral Vase consisting of 23 triangular spirals revolving 250 degrees from origin. Although it is hollow it can hold some water at the bottom.

It is not the easiest vase to print, especially near the throat where all spirals converge, the spirals will tend to "move" by the nozzle at the throat area as they become spring-like, you can add supports to avoid this issue.

I used standard 0.4mm nozzle, 0.2mm layer height, infill 30%. I didn't use supports but if I print it again I would add some custom tree supports.

100% scale is 210mm high, it will take around 30 hours to print, I was able to print it at 40% scale with no issue.