Thingiverse
Splat Dualies
door BossCrow
1
Downloads
6
Likes
0
Makes
I chopped the original models so each piece could be printed in the correct colour. I only really did this because I happened to have the correct colours anyway and I don't like painting if I can avoid it.
No fancy peg and hole fixing like the original, just superglue and a steady hand. I'll upload photos of the completed print once it finishes.
Upon finishing I'm quite happy with the result. I used cheap superglue, not recommended and the glue is doing a fair bit of work on the tanks. Loctite CA glue is best in my experience, bonds stronger than the PLA prints.
Stay fresh!
No fancy peg and hole fixing like the original, just superglue and a steady hand. I'll upload photos of the completed print once it finishes.
Upon finishing I'm quite happy with the result. I used cheap superglue, not recommended and the glue is doing a fair bit of work on the tanks. Loctite CA glue is best in my experience, bonds stronger than the PLA prints.
Stay fresh!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
