Split Goji for 270% scaling

I really liked the model that arumey put up here but I wanted a bigger one. The largest I could get onto my Anycubic I3 mega was around 140 percent. So I split goji into three pieces to allow each one to be scaled up to 270%. Bigger is better when it comes to ole Thunder Thighs, right?

I haven't had a chance to print this as I am waiting on a replacement part for my printer but I "think" it should come out OK.

Using Cura slice it to be:
walls/roof/floor - 5
layer height - .25
Enable Tree Support
Tree support branch distance - 4mm
branch diamater - 2mm
branch wall count - 2
Infil 5-10 % Cubic Subdivision