Thingiverse
Sploof - Activated carbon filter
by dirtcobain
80
Downloads
66
Likes
0
Makes
Just seal off one end of the filter and fill it with activated carbon. Seal off the other end and screw the filter into the cone.
I used the fabric of some old clothes and a rubber band to keep the carbon in place.
The threads can be a bit stubborn the first time you screw it in. Just work it back and forth a few times and you should be able to screw it in with just two fingers.
Added a shorter cone for faster printing. The short cone is 45° and is about 20mm shorter.
Short cone assembled:
65mm x 45mm
Long cone assembled:
85mm x 45mm
I used the fabric of some old clothes and a rubber band to keep the carbon in place.
The threads can be a bit stubborn the first time you screw it in. Just work it back and forth a few times and you should be able to screw it in with just two fingers.
Added a shorter cone for faster printing. The short cone is 45° and is about 20mm shorter.
Short cone assembled:
65mm x 45mm
Long cone assembled:
85mm x 45mm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
