Thingiverse
Sponge drain / Sponge holder
von uzi6574
48
Downloads
45
Likes
0
Makes
A Sponge Drain printed in two parts.
can hold a Sponge up to Size 95mm x 72mm
The print in two parts allows the Main part to be printed without an angel on its base this enables the use "Ironing" to ensure you have a smooth and water tight surface.
The Base part has three knobs to align with the main part. I still recommend to glue the two parts together
I included to base versions one with a with of 35 and one with 25 mm
shown on the Images is the 35mm Version
can hold a Sponge up to Size 95mm x 72mm
The print in two parts allows the Main part to be printed without an angel on its base this enables the use "Ironing" to ensure you have a smooth and water tight surface.
The Base part has three knobs to align with the main part. I still recommend to glue the two parts together
I included to base versions one with a with of 35 and one with 25 mm
shown on the Images is the 35mm Version
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
