MakerWorld
Other House Models
Voir le modèle
Sponge holder for sink
145
Téléchargements
53
Likes
40
Makes
I was looking for a sponge holder for my kitchen sink. As the model I found on thingiverse (Sponge holder for round sink in the kitchen by kimana - Thingiverse) did mot exactly fit my sink I remixed it. My changes were as follows: Added 6mm to Y to be fit larger sponges without squeezing.Extended the holder that goes around the foot of the tap by about 10mm as our tap is a bit further away from the sinks edge. Print settings: material: doesn't really matter (I used PLA)support: I used support for the nudges of the holder
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
