Thingiverse
Spontex Garage - Kitchen Sink
di posixp
69
Download
50
Likes
0
Makes
[](https://www.buymeacoffee.com/larsgs)
UPDATE: The "*NG" file has two slots from the bottom either for magnetic washers or up to 1.5mm sheet metal. Glue them in from the bottom and seal.
Get your dish washing sponge out of the marsh with the Spontex Garage!
Includes:
Sponge holder ("garage")
Magnet aligner
Mount:
* A strip of iron is glued to the backside of the sponge holder. I recommend a pair of galvanized shims. Ideally 20mm diameter.
* The magnets are placed on the opposite side of your kitchen sink. Sink must be thin enough for the magnets to pull the shims.
* Add dual sided tape to the aligner. The groove/recese is to compensate for thicker tape if you need to - You'll want your magnets as close as possible to the outside of the sink.
Slicing/Printing:
* Garage: Angled bottom surface flat to the bed. Your printer should be able to do a 55° overhang - most stock printers go "clean" as lo
UPDATE: The "*NG" file has two slots from the bottom either for magnetic washers or up to 1.5mm sheet metal. Glue them in from the bottom and seal.
Get your dish washing sponge out of the marsh with the Spontex Garage!
Includes:
Sponge holder ("garage")
Magnet aligner
Mount:
* A strip of iron is glued to the backside of the sponge holder. I recommend a pair of galvanized shims. Ideally 20mm diameter.
* The magnets are placed on the opposite side of your kitchen sink. Sink must be thin enough for the magnets to pull the shims.
* Add dual sided tape to the aligner. The groove/recese is to compensate for thicker tape if you need to - You'll want your magnets as close as possible to the outside of the sink.
Slicing/Printing:
* Garage: Angled bottom surface flat to the bed. Your printer should be able to do a 55° overhang - most stock printers go "clean" as lo
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
