Spool Adapter 75mm

On my Anycubic Kobra I found that the spools ironically from Anycubic had a much larger opening than the mount. To make it roll smoother I made this adapter big enough to fit over the thicker end stop, and a little smaller than the 75mm diameter opening so it fits easily inside. I also made it wider than the spool so if there is movement it stays on with no issues.
This should help any spool with a 75mm opening that goes on a smaller mount.
I have found in the last few prints I did with the same filament that they are smoother as the extruder is not constantly fighting with the spool rotation. They fight, and the print is the victim. Just not fair :)