Thingiverse
Spool Adapter Clip
von CurtisG890
0
Downloads
0
Likes
0
Makes
This is my first make. Wanted to move the Spool Holder on my Geeetech A30 from the control unit to the top of the printer to make it easier to store.
Just thread 2 M3*8 bolts to hold on the spool holder and clip onto the top of the printer.
No specific settings required - just make sure it's got a good enough infill to support the weight of the spool
Just thread 2 M3*8 bolts to hold on the spool holder and clip onto the top of the printer.
No specific settings required - just make sure it's got a good enough infill to support the weight of the spool
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
