Thingiverse
Spool drawer stopper
door GoTVm
1
Downloads
0
Likes
0
Makes
Simple drawer stopper. Stops your 3D printed spool drawers from opening themselves if they don't friction fit quite as they should.
Just drill a hole near the center of the spool and measure its width; then take the width and insert it into the .scad file I provided (in my specific case, I had to reduce it by 0.1 so that it wouldn't be too difficult to remove but still stayed put, YMMV).
Just drill a hole near the center of the spool and measure its width; then take the width and insert it into the .scad file I provided (in my specific case, I had to reduce it by 0.1 so that it wouldn't be too difficult to remove but still stayed put, YMMV).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
