Thingiverse
Spool holder 2040 - Split
door ssombra
3
Downloads
2
Likes
0
Makes
Update Feb 22, 2021:
I added a Version 2 with wider (10mm) and larger (15mm) columns for more rigidity.
I like the Filler spool holder and I was looking for one remix to use it in my AM8 printer (2040 extrusion) so I found Technoo10201 design; However, my print volume is not large enough to print it as it is, so I just took his design (thanks for the STEP file!), split it in two and added a couple of columns for alignment and easy assembly. I glued the pieces with CA glue and so far it works fine. I added a 0.05 mm gap between the pieces (columns) and it is a tight fit after printing them in my printer.
I added a Version 2 with wider (10mm) and larger (15mm) columns for more rigidity.
I like the Filler spool holder and I was looking for one remix to use it in my AM8 printer (2040 extrusion) so I found Technoo10201 design; However, my print volume is not large enough to print it as it is, so I just took his design (thanks for the STEP file!), split it in two and added a couple of columns for alignment and easy assembly. I glued the pieces with CA glue and so far it works fine. I added a 0.05 mm gap between the pieces (columns) and it is a tight fit after printing them in my printer.
ssombra publiceert ook op
22 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
