Thingiverse
Spool holder and Screen Break
von The_Grey_Jedi
5
Downloads
2
Likes
0
Makes
Couple of parts for the Ender 3.
First a static screen break for the stock Ender 3. This has stopped the really annoying bleeping and screen resetting all the time during prints (a common fault).
Second is a swivel mount for the OE spool arm. This allows you to fit the arm to the side rail if you already have issues with clearance above the Ender.
Both printed in 0.2mm Standard layer height with 20% infill in PLA (green is Amazon Basic, red is SUNLU).
Extra hardware:
Swivel Arm - 6 No. M5-10 and T nuts; 1No M3 40mm for the pivot (you can also use a nut but not really necessary).
Screan Break - 2 No. M5-10 and T nuts (re-uses the OE screen M5 screws)
First a static screen break for the stock Ender 3. This has stopped the really annoying bleeping and screen resetting all the time during prints (a common fault).
Second is a swivel mount for the OE spool arm. This allows you to fit the arm to the side rail if you already have issues with clearance above the Ender.
Both printed in 0.2mm Standard layer height with 20% infill in PLA (green is Amazon Basic, red is SUNLU).
Extra hardware:
Swivel Arm - 6 No. M5-10 and T nuts; 1No M3 40mm for the pivot (you can also use a nut but not really necessary).
Screan Break - 2 No. M5-10 and T nuts (re-uses the OE screen M5 screws)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
