Thingiverse
Spool Holder Anet A8
von Murphy06
19
Downloads
16
Likes
0
Makes
This spoolholder can be directly bolted to the top left corner of the frame of your Anet A8 3D printer. There is no need for any bearings etc. 100% 3D printed parts!
Regarding your concerns about the added weight on top of your printer, I did not observe any negative influence on printing quality after switching to that system.
Regarding your concerns about the added weight on top of your printer, I did not observe any negative influence on printing quality after switching to that system.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
