Thingiverse
Spool holder complement 608 bearings
von Stealth_NT
68
Downloads
41
Likes
0
Makes
This is a complement for TUSH spool holder:
https://www.thingiverse.com/thing:2047554
Since I was using a lot TUSH holders and I already have printed several of them I made this accessory for keep the spool in the same location, use any kind of rubber and glue it at the base if you have issues with this spool holders moving from they location due an slippery surface.
In use at the moment at a qidi tech 1, now the filament have more freedom for retractions.
This spool holder may fit on any normal size spool I use mostly hatchbox so the size was made for hatchbox spools.
https://www.thingiverse.com/thing:2047554
Since I was using a lot TUSH holders and I already have printed several of them I made this accessory for keep the spool in the same location, use any kind of rubber and glue it at the base if you have issues with this spool holders moving from they location due an slippery surface.
In use at the moment at a qidi tech 1, now the filament have more freedom for retractions.
This spool holder may fit on any normal size spool I use mostly hatchbox so the size was made for hatchbox spools.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
